COOLER EXPANSION VALVE > INSTALLATION |
| 1. INSTALL COOLER EXPANSION VALVE |
Apply sufficient compressor oil to 2 new O-rings and the fitting surfaces of the cooler expansion valve.
Install the 2 new O-rings onto the No. 1 cooler evaporator sub-assembly.
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
| 2. INSTALL AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY |
Remove the vinyl tape from the pipe.
Sufficiently apply compressor oil to a new O-ring and fitting surface of the air conditioner tube and accessory assembly.
Install the O-ring to the air conditioner tube and accessory assembly.
Install the air conditioner tube and accessory assembly.
| 3. INSTALL SUCTION HOSE SUB-ASSEMBLY |
Remove the vinyl tape from the pipe.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction hose sub-assembly.
Connect the O-ring to the suction hose sub-assembly.
Connect the suction hose sub-assembly.
Rotate the hook connector in the direction indicated by the arrow in the illustration.
![]() |
Insert the pipe joint into the cooler expansion valve securely and tighten the bolt.
| 4. CHARGE REFRIGERANT |
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):
| 5. WARM UP ENGINE |
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):
| 6. INSPECT FOR REFRIGERANT LEAK |
for HFC-134a (R134a):
for HFO-1234yf (R1234yf):