Home › Vehicle Interior › HEATING / AIR CONDITIONING › COOLER EXPANSION VALVE

COOLER EXPANSION VALVE > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. for HFC-134a (R134a):

  1. for HFO-1234yf (R1234yf):



2. SEPARATE SUCTION HOSE SUB-ASSEMBLY


    E246449
  1. Remove the bolt and slide the hook connector.

  1. Disconnect the suction hose sub-assembly.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



3. SEPARATE AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
  1. Disconnect the air conditioner tube and accessory assembly.

  1. Remove the O-ring from the air conditioner tube and accessory assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



4. REMOVE COOLER EXPANSION VALVE


    E246456
  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.



    E246457E01
  1. Temporarily install the bolt for the suction hose sub-assembly halfway to the cooler expansion valve.
    Text in Illustration 
    *1
    Bolt For The Suction Tube Sub-assembly



    E246458
  1. Hold the bolt and pull it to remove the cooler expansion valve as shown in the illustration.



    E246459E01
  1. Remove the 2 O-rings from the evaporator pipe.
    Text in Illustration 
    *1
    Evaporator Pipe