Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



1. CUSTOMIZE LIGHTING SYSTEM (EXT)

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.

  1. Customizing with the GTS

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Utility / Customize / Light Control.

    5. Select the setting by referring to the table below.

      Light Control 
      Display
      Default
      Content
      Setting
      Relevant ECU
      Response Time*1
      Normal
      Changes the delay timing of lighting the taillights when going into a tunnel when the light control switch is in the AUTO position.
      Normal or Long
      Main Body ECU (Network Gateway ECU)
      Light Auto OFF Delay*1
      30 s
      Keeps the headlights on for a certain period of time after turning the ignition switch off and closing all doors with the low beam headlights on.
      OFF, 30 s, 60 s or 90 s
      Follow Me Home Lighting Time*2
      30 s
      Changes the low beam headlight lighting time when ignition switch is off and dimmer switch is pulled to flash headlights once.
      30 s, 60 s, 90s, or 120s

      HINT:
      Items for which there are no settings do not appear on the GTS, or do not operate.

      1. *1: w/ Automatic Light Control System
      2. *2: w/ Follow Me Home System