Home › Vehicle Interior › SEAT BELT › CHILD RESTRAINT SEAT TETHER ANCHOR

CHILD RESTRAINT SEAT TETHER ANCHOR > INSTALLATION

for Preparation Click here



1. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
  1. Engage the hook and install the child restraint seat tether anchor bracket with the bolt.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    HINT:
    Use the same procedure for the 2 child restraint seat tether anchor brackets.



2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
  1. Engage the 4 clips and install the package tray trim panel assembly with the center stop light assembly.

  1. Install the 4 clips.

  1. Connect the connector.



3. INSTALL REAR WINDOW SIDE GARNISH LH
  1. Engage the guide and 2 clips.

  1. Install the rear window side garnish LH with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



4. INSTALL REAR WINDOW SIDE GARNISH RH

HINT:
Use the same procedure as for the LH side.



5. INSTALL QUARTER TRIM LID SUB-ASSEMBLY LH
  1. Install the 2 lid cover clips from the quarter trim lid sub-assembly LH.

    NOTICE:
    If there is any damage, be sure to replace the lid cover clip with a new one.



    B321466E01
  1. Engage the 2 guides and 6 claws and install the quarter trim lid sub-assembly LH.
    Text in Illustration 
    *1
    Lid Cover Clip



6. INSTALL QUARTER TRIM LID SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



7. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH
  1. Engage the 8 clips install the quarter trim panel assembly LH.

  1. Install the clip.



8. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

HINT:
Use the same procedure as for the LH side.



9. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B315249E01
  1. Align the alignment mark on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.
    Text in Illustration 
    *a
    Alignment Mark

    NOTICE:
    After installation, check that the corners fit correctly.



10. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure as for the LH side.



11. INSTALL FRONT DOOR SCUFF PLATE LH
  1. Engage the 6 claws install the front door scuff plate LH.



12. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side.



13. INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY
  1. Install the 2 bolts and bench type rear seatback assembly.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }

  1. Install the 3 clips and rear seatback cover.



14. INSTALL SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY LH
  1. Engage the hook and install the separate type rear seat cushion assembly LH.

  1. Install the bolt.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



15. INSTALL SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.