Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT

VANITY LIGHT > INSPECTION

for Preparation Click here



1. INSPECT VISOR ASSEMBLY


E235079E01
  1. Measure the resistance according to the value(s) in the table below.
    Standard Resistance 
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Mirror cover close
    10 kΩ or higher
    1 - 2
    Mirror cover open
    Below 1 Ω
    If the result is not specified, replace the bulb or the visor assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Visor Assembly)