Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR

BRAKE ACTUATOR > REASSEMBLY

for Preparation Click here



1. INSTALL BRAKE ACTUATOR DAMPER


    C261003E01
  1. Install the 3 new brake actuator dampers (A and B) to the brake actuator bracket assembly.



2. INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY


C261002
  1. Install the brake actuator bracket assembly to the brake actuator assembly with the 3 new nuts and 3 new washers.

    NOTICE:
    Do not remove the hole plugs of a new brake actuator assembly before connecting the brake lines because the brake actuator assembly is filled with brake fluid.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }