Home › Drivetrain ยท TL70 MANUAL TRANSMISSION / TRANSAXLE › INPUT SHAFT

INPUT SHAFT > INSPECTION

for Preparation Click here



1. INSPECT NO. 2 SYNCHRONIZER RING


    C257058
  1. Apply manual transmission gear oil to the taper corn of the 3rd gear, and hold the No. 2 synchronizer ring in position with your hand to measure the clearance between the No. 2 synchronizer ring and 3rd gear by using a feeler gauge.

    Standard clearance:
    0.8 to 1.6 mm (0.0315 to 0.0630 in.)

    Minimum clearance:
    0.8 mm (0.0315 in.)

    NOTICE:
    Check the entire circumference of the gear.

    HINT:
    If the clearance is less than the minimum, replace the No. 2 synchronizer ring with a new one.



    C257057
  1. Apply manual transmission gear oil to the taper cone of the 3rd gear, and then hold the No. 2 synchronizer ring in position with your hand to check that it does not slide in the circumferential direction.

    HINT:
    If the No. 2 synchronizer ring slides, replace the No. 2 synchronizer ring with a new one.