ENTRY AND START SYSTEM (for Start Function) > CUSTOMIZE PARAMETERS |
| 1. CUSTOMIZE ENTRY AND START SYSTEM (for Start Function) |
Customizing with the GTS
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body or Entry & Start / Utility / Customize / Entry & Start or Warning.
Select the setting by referring to the table below.
| Display | Default | Content | Setting | Relevant ECU |
| Ignition Available Area | All | Function that sets the area that the key must be in before the engine switch can be operated. | Front or All | Certification ECU (smart key ECU assembly) |
| Engine Start Indicator | ON | Function to Turn ON / OFF of the Engine Start Indicator. | OFF or ON | Certification ECU (smart key ECU assembly) |
| Auto Entry Cancel SW | OFF | Function that enables or disables the entry and start system. | OFF or ON | Certification ECU (smart key ECU assembly) |
| Display | Default | Content | Setting | Relevant ECU |
| Key Low Battery Warning | ON | Function that enables or disables the sounding of the buzzer when the key battery is low and the engine switch is turned off after being on (IG) for 20 minutes or more. | OFF or ON | Certification ECU (smart key ECU assembly) |
Entry cancel function (manual operation)
The following functions are disabled when the entry and start system is canceled.
Canceling the system operation:
Perform the following procedure to restore the entry and start system to the active state from the canceled state.