Home › Drivetrain ยท TL70 MANUAL TRANSMISSION / TRANSAXLE › SHIFT LEVER ASSEMBLY

SHIFT LEVER ASSEMBLY > ADJUSTMENT

for Preparation Click here



1. ADJUST SHIFT LEVER POSITION


    C260584
  1. Loosen the 4 bolts of the shift lever cap. [*1]

  1. Move the shift lever to 2nd. [*2]



    C306719E01
  1. Insert a 1 mm (0.03937 in.) feeler gauge between the stopper and the shift lever cap, and push the shift lever cap against the stopper. [*3]
    Text in Illustration 
    *1
    Shift Lever Cap
    *2
    Stopper
    *3
    Feeler Gauge
    *a
    1.0 mm (0.03937 in.)
    V100136
    Push



    C306721E01
  1. While keeping the clearance gap between the stopper and the shift lever cap parallel, tighten the 4 bolts to the specified torque. [*4]

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    After tightening the bolts, check that there is an equal amount of clearance gap between the stopper and the shift lever cap.

    Text in Illustration 
    *a
    Correct
    *b
    Incorrect
    V100135
    Front of vehicle

  1. Depress the clutch pedal and check that the shift lever can be moved to 1st and 2nd.

  1. If the shift lever cannot be moved to 1st and 2nd, repeat steps [*1] to [*4] , decreasing the thickness of the feeler gauge in increments of 0.2 mm (0.00787 in.) until the shift lever can be moved to 1st and 2nd.

  1. Depress the clutch pedal and check that the shift lever can be moved to 1st and 2nd.

  1. After adjusting the position of the shift lever, apply MP grease to the stopper and shift lever cap.