Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for LED Headlight)

HEADLIGHT ASSEMBLY (for LED Headlight) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RH and LH sides.
  2. The procedure listed below is for LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT BUMPER COVER
(Click here)


3. REMOVE FRONT BUMPER SIDE SUPPORT LH


    B312179
  1. Disengage the 2 clamps to disconnect the wire harness.



    B312702E01
  1. Remove the bolt A.

  1. Remove the 3 bolts B and the front bumper side support LH.



4. REMOVE HEADLIGHT ASSEMBLY
  1. Disconnect each connector.



    B312181
  1. Remove the clip.

  1. Remove the bolt.

  1. Disengage the claw to remove the headlight assembly.