Home › Vehicle Exterior › BODY WELD POINT › QUARTER PANEL
BM19Y0E _01 Vehicle Exterior _060208 BODY WELD POINT _0295212 QUARTER PANEL F

BODY WELD POINT  QUARTER PANEL  CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)  


K102430

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location
K108828

Cut Location for Supply Parts

REMOVAL POINT
1.

*1 in illustration above indicates where the adhesive is located.

2.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.




K137059E01
2,5.333 1.917,5.333 1.917,5.333 1.969,5.063 false 1.552,2.031 2.271,2.448 0.719,0.417 10 false 175 (6.89) 2.042,5.219 2.354,5.417 0.313,0.198 10 false *1 0.208,8.448 0.802,8.865 0.594,0.417 10 false mm (in.)

INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108831

Butt Weld
K108834

Body Sealer


INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

Before installing a new part, apply body sealer.

HINT:
·

Apply body sealer evenly about 5 mm (0.20 in.) from the flange, avoiding any oozing.

·

Apply body sealer evenly, about 3 to 4 mm (0.12 to 0.16 in.) in diameter.



4.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115) to the area indicated by *1 in the illustration.

HINT:

Apply enough adhesive for the panels to stick to each other.


5.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

6.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K137060E01
2.583,3.917 2.417,3.917 2.417,3.917 1.896,3.51 false 1.833,5.417 1.75,5.417 1.75,5.417 1.813,5.167 false 2.667,3.823 3.938,4.323 1.271,0.5 10 false QUARTER PANEL 5.354,4.052 6.583,4.25 1.229,0.198 10 false 5 (0.20) 1.875,5.313 2.188,5.51 0.313,0.198 10 false *1 0.271,8.417 0.833,8.865 0.563,0.448 10 false mm (in.)