Home › Vehicle Exterior › BODY WELD POINT › BACK DOOR OPENING TROUGH
BM19Y0E _01 Vehicle Exterior _060208 BODY WELD POINT _0295215 BACK DOOR OPENING TROUGH F

BODY WELD POINT  BACK DOOR OPENING TROUGH  ASSEMBLY REPLACEMENT  


K102433

With the quarter panel removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108819

Remove Weld Points
K108820

Remove Weld Points

REMOVAL POINT
1.

*1: Bolts.



K137075E01
6.417,8.167 6.333,8.167 6.333,8.167 6.292,7.865 false 0.688,4.135 1.24,4.375 0.552,0.24 12 false LH: 2.281,4.135 2.833,4.375 0.552,0.24 12 false RH: 6.49,8.073 6.802,8.271 0.313,0.198 10 false *1

INSTALLATION


Symbol Meaning
K108821

Spot Weld
K108823

Plug Weld
K108824

Plug Weld
K108825

Plug Weld


INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

*1: Bolts.

4.

When welding *2, make a hole on a new part for plug welding and weld the panel with the panel behind completely.

5.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

6.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K137076E01
6.083,8.167 7.042,8.417 0.958,0.25 0.281,8.396 1.573,8.646 1.292,0.25 1.979,2.083 2.667,0.917 2.667,0.917 2.833,0.917 false 6.313,7.865 6.417,8.083 6.417,8.083 6.5,8.083 false 1.51,0.552 1.823,0.75 0.313,0.198 10 false *2 2.927,0.823 5.448,1.292 2.521,0.469 10 false QUARTER PANEL EXTENSION OUTER 5.854,4.917 6.167,5.115 0.313,0.198 10 false *2 6.563,7.99 6.875,8.188 0.313,0.198 10 false *1 6.135,8.188 7.052,8.594 0.917,0.406 10 false 17.5 (178, 13) 0.688,4.135 1.24,4.375 0.552,0.24 12 false LH: 2.271,4.135 2.823,4.375 0.552,0.24 12 false RH: 0.333,8.417 1.667,8.865 1.333,0.448 10 false N*m (kgf*cm, ft.*lbf) 1.625,8.417 2.792,8.865 1.167,0.448 10 false : Specified torque