Home › Vehicle Exterior › BODY WELD POINT › ROOF PANEL
BM19Y0E _01 Vehicle Exterior _060208 BODY WELD POINT _0295225 ROOF PANEL F

BODY WELD POINT  ROOF PANEL  ASSEMBLY REPLACEMENT  


K102444

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108820

Remove Weld Points
K108826

Cut with Disc Sander etc.


K137106

INSTALLATION


Symbol Meaning
K108821

Spot Weld
K108823

Plug Weld
K108825

Plug Weld
K108830

Fillet Weld
K108834

Body Sealer


INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After the roof panel reinforcement is welded to the new parts, install the roof panel to the vehicle side.

4.

Before temporarily installing the new parts, apply body sealer to the windshield header panel, roof panel reinforcement and back door opening frame.

HINT:

Apply just enough body sealer for the new parts to make contact.


5.

After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)

6.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

7.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K137107

K137108E01
6.5,4.667 6.667,4.667 6.667,4.667 6.365,3.458 false 5.531,4.573 6.479,5.073 0.948,0.5 10 false ROOF PANEL 0.906,7.25 1.521,7.698 0.615,0.448 10 false 11 (0.43) 5.719,7.25 6.333,7.698 0.615,0.448 10 false 11 (0.43) 0.333,8.417 0.948,8.865 0.615,0.448 10 false mm (in.)