Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING OR REPLACING PARTS › 2011.11–2015.08
BM19Y0E _V1 General _060205 INTRODUCTION _0295247 WHEN REMOVING,INSTALLING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Procedures Necessary when ECU or Other Parts are Replaced
Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed Note
·

Automatic transmission assembly

·

Valve body assembly

·

Any of the shift solenoid valve

·

Engine assembly

·

ECM


Reset memory Large shift shock -
for 3SZ-VE
·

Throttle body

·

ECM


Learning values write Engine starting
Idling
-
for K3-VE
·

Throttle body

·

ECM


Learning values write Engine starting
Idling
-
w/ Engine Immobiliser System

Transponder Key


ECU communication ID registration Engine start Refer to Service Bulletin
w/ Wireless Door Lock Control System
·

Door Control Transmitter

·

Door Control Receiver


Code registration Wireless door lock control system -