With the radiator support removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut with Disc Sander etc. |
Remove the front part of the front side member sub-assembly.
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Spot Weld |
|
Spot Weld |
|
Plug Weld |
|
Plug Weld |
|
Fillet Weld |
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.
If the entire supply part is not needed, remove the part of the supply part that is needed.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.