Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
| *1 | BACK DOOR NAME PLATE | *2 | NO. 3 BACK DOOR NAME PLATE |
| *3 | NO. 4 BACK DOOR NAME PLATE | *4 | RADIATOR GRILLE (OR FRONT PANEL) EMBLEM |
| ● | Non-reusable part | - | - |
RADIATOR GRILLE (OR FRONT PANEL) EMBLEM (for Back Door)
| *1 | Boss |
BACK DOOR NAME PLATE
| *a | 113.0 mm (4.448 in.) |
| *b | 22.4 mm (0.881 in.) |
| *c | 99.0 mm (3.897 in.) |
NO. 3 BACK DOOR NAME PLATE
| *a | 111.0 mm (4.370 in.) |
| *b | 116.0 mm (4.556 in.) |
| *c | 11.0 mm (0.433 in.) |
| *d | 50.0 mm (1.968 in.) |
| *e | 113.0 mm (4.448 in.) |
NO. 4 BACK DOOR NAME PLATE
| *a | 116.0 mm (4.566 in.) |
| *b | 50.0 mm (1.968 in.) |
| *c | 112.0 mm (4.409 in.) |