CONSTRUCTION
The No. 1 Crankshaft Position Sensor Plate consists of 30 teeth, with 2 teeth missing.
The crankshaft position sensor outputs the crankshaft rotation signals every 10°, and the missing teeth are used to determine the top-dead-center.
To detect the camshaft position, a timing rotor on the intake camshaft is used to generate 3 pulses for every 2 revolutions of the crankshaft.
| *1 | No. 1 Crankshaft Position Sensor Plate
(Timing Sprocket) |
*2 | Crankshaft Position Sensor |
| *3 | Timing Rotor | *4 | Camshaft Position Sensor |