Home › Engine / Hybrid System › K3-VE ENGINE MECHANICAL › ENGINE UNIT › 2011.11–2015.08
NM19Y0E _51 Engine / Hybrid System _003175 K3-VE ENGINE MECHANICAL _0016000 ENGINE UNIT GE GENERAL F

K3-VE ENGINE MECHANICAL  ENGINE UNIT  GENERAL  GENERAL  


OUTLINE


a.

The K3-VE engine is a 1.3-liter, 16-valve DOHC, in-line 4-cylinder gasoline engine.


b.

This engine uses the Variable Valve Timing-intelligent (VVT-i) system, Direct Ignition System. These systems achieve improved engine performance, fuel economy and clean emissions.

W105191



SPECIFICATION


Item Specification
Engine Type K3-VE
No. of Cyls. and Arrangement 4-cylinder, In-line
Valve Mechanism 16-valve DOHC, Chain Drive (with VVT-i)
Combustion Chamber Pentroof Type
Flow of Intake and Exhaust Gasses Cross-Flow
Fuel System SFI
Ignition System DIS
Displacement 1298 cm3 (79.2 cu. in.)
Bore x Stroke 72.0 mm X 79.7 mm (2.83 in. X 3.14 in.)
Compression Ratio 10.0 : 1
Max. Output [EEC] 67 kW @ 6000 rpm
Max. Torque [EEC] 117 N*m @ 4400 rpm
Valve Timing Intake Open 30°BTDC to 12°ATDC
Closed 10°ABDC to 52°ABDC
Exhaust Open 30°BBDC
Closed 2°ATDC
Firing Order 1 - 3 - 4 - 2
Fuel Unleaded Gasoline
Research Octane Number (RON) 90 or higher
Oil Grade API grade SL , SM or ILSAC Multigrade Engine Oil
Emission Regulation EURO 2
Engine Service Mass* (Reference) 95 kg (209 lb)

*: Weight shows the figure with oil and water fully filled.


W105192E04
2.052,1.406 2.542,1.74 0.49,0.333 10 120 2.052,1.698 2.469,2 0.417,0.302 10 110 2.052,1.979 2.521,2.313 0.469,0.333 10 100 2.125,2.271 2.458,2.563 0.333,0.292 10 90 2.125,2.563 2.5,2.885 0.375,0.323 10 80 1.938,0.896 2.521,1.25 0.583,0.354 10 (N*m) 4.896,1.115 5.313,1.448 0.417,0.333 10 80 4.896,1.406 5.271,1.698 0.375,0.292 10 70 4.896,1.698 5.323,2.031 0.427,0.333 10 60 4.896,1.979 5.25,2.26 0.354,0.281 10 50 4.896,2.271 5.25,2.542 0.354,0.271 10 40 4.896,2.552 5.26,2.844 0.365,0.292 10 30 4.896,2.844 5.229,3.156 0.333,0.313 10 20 4.896,3.135 5.198,3.396 0.302,0.26 10 10 4.896,3.427 5.167,3.708 0.271,0.281 10 0 4.823,0.865 5.354,1.188 0.531,0.323 10 (kW) 5.375,1.979 6.063,2.365 0.688,0.385 10 Output 1.406,1.969 2.125,2.448 0.719,0.479 10 Torque 2.938,4.146 4.573,4.552 1.635,0.406 10 Engine Speed (rpm) 3.427,3.75 3.99,4.115 0.563,0.365 10 4000 3.052,3.75 3.583,4.083 0.531,0.333 10 3000 2.677,3.75 3.198,4.063 0.521,0.313 10 2000 2.292,3.75 2.76,4.021 0.469,0.271 10 1000 3.823,3.75 4.292,4.073 0.469,0.323 10 5000 4.198,3.75 4.698,4.094 0.5,0.344 10 6000 4.583,3.75 5.135,4.156 0.552,0.406 10 7000 0.146,0.188 2.104,0.552 1.958,0.365 12 Performance Curve :


MAIN FEATURES


a.

The K3-VE engine has achieved the following performance through the adoption of the items listed below.

i.

High performance and reliability


ii.

Low noise and vibration


iii.

Lightweight and compact design


iv.

Good serviceability


v.

Clean emission and fuel economy

Item (1) (2) (3) (4) (5)
Engine Proper A precision cast-iron cylinder block is used. ○ - - - -
An offset crankshaft is used. ○ ○ - - ○
An aluminum oil pan sub-assembly is used. - - ○ - -
Low-tension piston rings are used. ○ - - - ○
Valve Mechanism A timing chain and chain tensioner are used. - ○ - ○ -
The Variable Valve Timing-intelligent (VVT-i) system is used. ○ - - - ○
A shimless type valve lifters are used. - - ○ - -
Cooling System Toyota Genuine Super Long Life Coolant (SLLC) is used. - - - ○ -
Intake and Exhaust System A plastic intake manifold is used. - - ○ - -
A stainless steel exhaust manifold is used. - - ○ - -
Three-Way Catalytic converter (TWC) is used. - - - - ○
Fuel System 4-hole type fuel injector assemblies are used. ○ - - - ○
A fuel returnless system is used. - - ○ ○ ○
Quick connectors are used to connect the fuel tube and fuel pipes or pulsation damper. - - - ○ -
Ignition System A Direct Ignition System is used. ○ - - ○ ○
Engine Control System The flat type knock sensor is used. ○ - - - -