CONSTRUCTION
Precision cast-iron is used for the cylinder block.
The components listed below have been integrated in the cylinder block to reduce the number of the parts. (water pump swirl chamber, chamber for the oil pump rotor, generator bracket, air compressor bracket)
| *1 | Water Pump Assembly | *2 | Oil Pump Assembly |
| *a | Generator Bracket | *b | Water Pump Swirl Chamber |
| *c | Oil Pump Rotor Chamber | *d | Air Compressor Bracket |
Through the using of the offset crankshaft, the bore center is shifted 8 mm towards the exhaust, in relation to the crankshaft center. Thus, reduces the side force to the cylinder wall when the maximum pressure is applied and contributes to fuel economy.
| *A | Offset Crankshaft | *B | Non-offset Crankshaft |
| *a | Bore Centerline | *b | Crankshaft Centerline |
| *c | 8 mm (0.31 in.) | - | - |
|
Maximum Pressure | - | - |