Home › Engine / Hybrid System › 3SZ-VE COOLING › COOLING SYSTEM › 2011.11–2014.04
NM19Y0E _51 Engine / Hybrid / EV System _003184 3SZ-VE COOLING _0016011 COOLING SYSTEM GE GENERAL F

3SZ-VE COOLING  COOLING SYSTEM  GENERAL  GENERAL  


OUTLINE


·

The cooling system is a pressurized, forced-circulation type.

·

A system in which the intake side of the cylinder head is cooled in advance by the coolant returning from the radiator to the engine is used.

·

A thermostat with a bypass valve is located in the water inlet housing to maintain a suitable temperature in the cooling system.

·

An air bleeder valve has been provided on the coolant pipe to make changing engine coolant easier. Further, vehicles equipped with heaters have been fitted with one air relief valve on the coolant pipe and one on the heater hose.

·

A single electronic cooling fan is used for both the cooling and air conditioning systems.


W105715C01
3.865,0.844 4.438,0.25 4.438,0.25 4.479,0.25 true 1.958,1.75 1.5,2.104 1.5,2.104 1.427,2.104 true 2.323,1.885 1.563,2.604 1.563,2.604 1.5,2.604 true 2.375,1.969 1.688,3.063 1.688,3.063 1.646,3.063 true 3.865,4.313 4.458,3.656 4.458,3.656 4.521,3.656 true 2.021,3.938 2.219,3.615 2.219,3.615 2.271,3.615 true 1.948,5.24 1.438,5.729 1.438,5.729 1.385,5.729 true 2.323,5.365 1.604,6.135 1.604,6.135 1.531,6.135 true 2.375,5.448 1.76,6.521 1.76,6.521 1.688,6.521 true 1.219,2.021 1.417,2.188 0.198,0.167 10 *2 1.292,2.521 1.49,2.688 0.198,0.167 10 *3 1.438,2.979 1.635,3.146 0.198,0.167 10 *4 4.542,0.177 4.75,0.365 0.208,0.188 10 *1 4.573,3.573 4.781,3.74 0.208,0.167 10 *1 2.333,3.542 2.542,3.708 0.208,0.167 10 *5 1.177,5.646 1.385,5.813 0.208,0.167 10 *2 1.333,6.063 1.542,6.229 0.208,0.167 10 *3 1.479,6.458 1.688,6.625 0.208,0.167 10 *4 1.552,4.385 1.771,4.542 0.219,0.156 10 *a 1.583,4.542 1.802,4.698 0.219,0.156 10 *b 0.781,0.104 1.083,0.354 0.302,0.25 10 *A 0.781,3.479 1.083,3.729 0.302,0.25 10 *B
*A Models without Heater *B Models with Heater
*1 Water Hose Joint *2 Water Outlet
*3 Thermostat *4 Water Inlet
*5 Air-breeding Valve - -
*a From Heater *b To Heater
V100135

Water Flow - -



SPECIFICATION


a.

Engine Coolant

·

Toyota Genuine SLLC is used. The maintenance interval is as shown in the table below:


Engine Coolant Type Toyota Genuine Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids). Do not use plain water alone.
Maintenance Intervals First Time 160000 km (100000 miles)
Subsequent Every 80000 km (50000 miles)
Density 30%
Color Pink

HINT:
·

A 30% concentration of the SLLC is used in K3-VE engine. However, SLLC is a 50% concentration, which is premixed with 50% deionized water. When refilling, always dilute it to a 30% concentration ratio.

·

We recommend using deionized water or distilled water as the diluting solution.




b.

Thermostat

Thermostat Opening Temperature 78°C to 82°C (172°F to 179°F)
Fully-open Lift Amount 8.5 mm (0.33 in.) or more at 93°C (199°F)