CONSTRUCTION
Shift Mechanism
The M5S manual transmission has the following 4 types of mechanism to prevent gear jump out and double-meshing.
Reverse One-way Mechanism
When the reverse shift head moves toward both the 5th gear and the reverse gear, the reverse one-way mechanism operates the reverse shift arm only when the reverse shift head is moved toward the reverse gear side.
When the gear shift is shifted to the reverse gear side, the pin connected to the reverse shift head pushes the reverse shift arm to the left along the hole in the reverse shift arm bracket. This move causes the reverse shift arm to move the reverse idler gear to the reverse gear meshing position.
When the gear shift is shifted to the 5th gear side, the pin connected to the reverse shift head moves to the right along the hole in the reverse shift arm bracket. At this time, the hole in the reverse shift arm bracket and the hole in the reverse shift arm are aligned, so the pin moves to the right without pushing the reverse shift arm. As a result, even when shifting into 5th gear, the reverse shift arm does not move.
| *A | Reverse | *B | 5th |
| *1 | Reverse Head | *2 | Reverse Shift Arm Bracket |
| *3 | Pin | *4 | Reverse Shift Arm Sub-assembly |
| *5 | Reverse Idler Gear Sub-assembly | *6 | Reverse Gear |
| *a | Shifting direction to Reverse | *b | Shifting direction to 5th |
Clattering Noise Prevention Mechanism (for Reverse Gear)
When shifting to the reverse, this mechanism prevents clattering noise.
When shifting to the reverse, the hub sleeve is pushed to the right side and the shifting key is moved to the right side.
At this time, the shifting key moved to the right side generates the friction between tapers of synchronizer ring and 3rd gear, and this friction stop the input shaft rotation. As a result, reverse idler gear and reverse gear are engaged without clattering noise.
| *1 | 5th Gear | *2 | Hub Sleeve |
| *3 | Shifting Key | *4 | 3rd Gear |
| *5 | Synchronizer Ring | - | - |
|
Moving Direction | - | - |