CONSTRUCTION
The brake actuator assembly consists of the actuator portion and skid control ECU.
| *1 | Skid Control ECU | *2 | Actuator Portion |
The actuator portion consists of 4 pressure holding solenoid valves, 4 pressure reduction solenoid valves, 2 pumps, and 2 reservoirs.
| *1 | Pressure Holding Solenoid Valve | *2 | Pressure Reduction Solenoid Valve |
| *3 | Pump | *4 | Reservoir |
| *5 | Front Left Wheel Cylinder | *6 | Rear Right Wheel Cylinder |
| *7 | Rear Left Wheel Cylinder | *8 | Front Right Wheel Cylinder |
| *a | From Master Cylinder | - | - |
OPERATION
ABS and EBD
Based on the signals received from the 4 speed sensors, the skid control ECU calculates the speed of each wheel, and checks wheel slipping conditions. In accordance with the slipping condition, the skid control ECU controls each solenoid valve in the brake actuator assembly in order to adjust the fluid pressure of each wheel cylinder in the following 3 modes: pressure increase, pressure holding, and pressure reduction modes.
| *1 | Pressure Holding Solenoid Valve | *2 | Pressure Reduction Solenoid Valve |
| *3 | Port A | *4 | Port B |
| *a | Pressure Increase Mode | *b | Pressure Holding Mode |
| *c | Pressure Reduction Mode | *d | To Wheel Cylinder |
| *e | From Wheel Cylinder | - | - |
| Pressure Mode | Increase Mode | Holding Mode | Reduction Mode |
|---|---|---|---|
| Pressure Holding Solenoid Valve (Port A) | Off (Open) | On (Closed) | ← |
| Pressure Reduction Solenoid Valve (Port B) | Off (Closed) | ← | On (Open) |
| Wheel Cylinder Pressure | Increases | Holds | Reduces |