Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.11–2015.08
NM19Y0E _55 Steering _003202 POWER ASSIST SYSTEMS _0016030 POWER STEERING SYSTEM CO CONTROL F

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  CONTROL  POWER STEERING CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Steering Column Assembly Power Steering Motor Generates power assist in accordance with a signal received from the power steering ECU assembly.
Reduction Mechanism Reduces the speed of the power steering motor through the use of a worm gear and a wheel gear and transmits it to the column shaft.
Power Steering Torque Sensor Detects the amount of twist of the torsion bar. Based on the torque applied to the torsion bar, the sensor creates an electrical signal, and outputs this signal to the power steering ECU assembly.
Combination Meter Assembly Power Steering Warning Light Lights up to alert the driver when the power steering ECU assembly detects a malfunction in the EPS system.
Speedometer Outputs the vehicle speed signal to the power steering ECU assembly.
Power Steering ECU Assembly
·

Actuates the power steering motor mounted on the steering column assembly to provide power assist, based on the signals received from various sensors and ECUs.

·

Outputs idle up request signals to the ECM.


ECM Outputs the engine speed signal to the power steering ECU assembly.


SYSTEM CONTROL


Controls of EPS System
Control Outline
Basic Control Calculates the assist current and assist direction from the steering torque value and the vehicle speed, and actuates the power steering motor.
Inertia Compensation Control Ensures the starting movement of the power steering motor when the driver starts to turn the steering wheel.
Friction Compensation Control Reduces steering wheel operation friction, improving steering feeling.
Recovery Control During the short interval between the time the driver fully turns the steering wheel and the wheels try to recover, this control assists the recovery force.
Damper Control Regulates the amount of assist when the driver turns the steering wheel while driving at high speeds, thus damping the changes in the yaw rate of the vehicle body.
Voltage Boost Control Boosts the battery voltage in the power steering ECU assembly, and issues the amount of voltage necessary to drive the power steering motor.
System Overheat Protection Control Estimates the power steering motor temperature based on the amperage and the current duration. If the temperature exceeds the standard, it limits the amperage to prevent the power steering motor from overheating.


FAIL-SAFE


a.

Fail-safe operation modes are as follows:

Detection Item Fail-safe
Power Steering Torque Sensor Malfunction Disables the assist.
Power Steering Motor Overheat Limits the assist force.
Power Steering Motor Short (Including Drive System Malfunction) Disables the assist.
Power Steering Motor Overcurrent Disables the assist.
Power Steering ECU Assembly Internal Temperature Sensor Malfunction Limits the assist force.
Power Steering ECU Assembly System Malfunction Disables the assist.
Vehicle Speed and Engine Speed Signal Malfunction Pauses the assist (provides normal assist after the signals recover).
Power Supply Voltage Malfunction Pauses the assist (provides normal assist after the voltage recovers).



DIAGNOSIS


a.

If the power steering ECU assembly detects a malfunction in the EPS system, the power steering ECU assembly lights up the power steering warning light in order to alert the driver. At the same time, Diagnostic Trouble Codes (DTCs) are stored in memory.


b.

The DTCs can be read by connecting the intelligent tester II to the DLC3. For details, refer to the corresponding Repair Manual for this model.