Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.11–2015.08
NM19Y0E _55 Steering _003202 POWER ASSIST SYSTEMS _0016030 POWER STEERING SYSTEM DE DETAILS F

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  DETAILS  POWER STEERING MOTOR  


CONSTRUCTION


a.

A low-inertia, low-noise, high power output DC motor is used.


b.

The operating range of the power steering motor is 8 to 16 V.


c.

The power steering motor consists of the rotor, stator and motor shaft.


d.

The torque generated by the power steering motor is transmitted via the joint to the worm gear. This torque is then transmitted via the wheel gear to the column shaft.

X106593
2.74,2.104 3.729,2.969 3.729,2.969 3.917,2.969 true 2.635,1.469 2.146,0.979 2.146,0.979 1.958,0.979 true 3.375,1.5 2.771,0.625 2.771,0.625 2.594,0.625 true 2.542,2.313 1.719,2.677 1.719,2.677 1.542,2.677 true 4.406,1.333 5,0.5 5,0.5 5.177,0.5 true 3.958,2.906 5.073,3.802 1.115,0.896 10 *3 1.792,0.917 2.5,1.594 0.708,0.677 10 *1 1.365,2.594 2,3.271 0.635,0.677 10 *2 2.417,0.552 3.094,1.156 0.677,0.604 10 *4 5.229,0.438 5.99,1.021 0.76,0.583 10 *5
*1 Worm Gear *2 Wheel Gear
*3 Column Shaft *4 Motor Shaft
*5 Power Steering Motor - -