Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2011.11–2015.08
NM19Y0E _58 Vehicle Interior _003212 HEATING / AIR CONDITIONING _0016041 AIR CONDITIONING SYSTEM DE DETAILS F

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  DETAILS  COOLER CONDENSER  


CONSTRUCTION


a.

The cooler condenser assembly consists of 2 cooling portions: a condensing portion and a super-cooling portion. These portions are integrated with a gas-liquid separator (modulator). This cooler condenser assembly uses a sub-cool cycle that offers excellent heat-exchange performance.


b.

In the sub-cool cycle, after the refrigerant passes through the condensing portion of the condenser, both the liquid refrigerant and the gaseous refrigerant that could not be liquefied are cooled again in the super-cooling portion. Thus, the refrigerant is sent to the evaporator in an almost completely liquefied state.


c.

The desiccant and filter at the bottom of the modulator remove moisture and debris from the refrigerant.

Y112898
2.406,0.979 1.844,0.385 1.844,0.385 1.677,0.385 true 1.292,2.417 0.771,2.74 0.771,2.74 0.563,2.74 true 1.24,1.927 0.844,1.552 0.844,1.552 0.635,1.552 true 1.458,0.271 1.875,0.646 0.417,0.375 10 *1 0.396,2.667 0.896,3.073 0.5,0.406 10 *3 0.448,1.479 0.917,1.865 0.469,0.385 10 *2
*1 Modulator *2 Desiccant
*3 Filter - -
V100137

Gaseous Refrigerant
V100135

Condensing Portion
V100136

Super-cooling Portion
V100138

Liquid Refrigerant


HINT:

The point at which the air bubbles disappear in the refrigerant of the sub-cool cycle is lower than the proper amount of refrigerant with which the system must be filled. Therefore, if the system is recharged with refrigerant based on the point at which the air bubbles disappear, the amount of refrigerant would be insufficient. As a result, the cooling performance of the system would be affected. Overcharging the system with refrigerant will also lead to reduced performance. For the proper method of verifying the amount of refrigerant and for instructions on how to recharge the system with refrigerant, refer to the Repair Manual.


Y114715
2.875,2 3.5,2 false 1.01,1.271 2.219,1.802 1.208,0.531 10 High Pressure 3.552,1.927 5.865,2.354 2.313,0.427 10 Point in which Bubbles Disappear 5.083,2.281 6.771,2.708 1.688,0.427 10 Amount of Refrigerant 2.76,0.979 4.771,1.5 2.01,0.521 10 Proper Recharged Amount