Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM › 2011.11–2015.08
NM19Y0E _58 Vehicle Interior _003208 DOOR LOCK _0016055 WIRELESS DOOR LOCK CONTROL SYSTEM CO CONTROL F

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM  CONTROL  WIRELESS DOOR LOCK CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components of the wireless door lock control system have the following functions:

Component Function
Door Control Receiver
·

Drives all door lock motors in response to signals.


·

Receives a lock or unlock signal from the transmitter.


Door Lock Assembly Door Lock Motor Drives the motor in response to signals from the door control receiver and locks or unlocks the doors.
Door Lock Switch Sends a lock or unlock request signal to the door control receiver by operation of the door key cylinder or the door lock knob.
Door Courtesy Light Switch Assembly Detects whether the doors are open or closed and sends this information to the door control receiver.



FUNCTION


a.

The wireless door lock control system has the following functions:

Function Outline
All Doors Lock Pressing the lock button of the transmitter locks all doors.
All Doors Unlock Pressing the unlock button of the transmitter unlocks all doors.
Speed-sensitive Automatic Door Lock*1 When the conditions listed below are met, this function causes all the doors to be automatically locked.
·

Vehicle speed is higher than approximately 20 km/h (12 mph).


·

All doors are closed.


·

Any one of the doors is in an unlocked state.


Speed-sensitive Automatic Door Unlock*1 When the doors are locked by speed-sensitive automatic door lock function, and the conditions listed below are met, this function causes all the doors to be automatically unlocked.
·

All doors are closed.


·

Any one of the doors is in a locked state.


·

The ignition switch is turned to OFF.


Repeat
·

If a door is not locked in response to the locking operation of the door control transmitter, the door control receiver will output a lock signal again after 1 second passes.


·

If a door is not unlocked in response to the unlocking operation of the door control transmitter, the door control receiver will output a unlock signal again after 1 second passes.


Automatic Lock If none of the doors and hood*1 is opened for 40 seconds*1 or 30 seconds*2 after being unlocked by the wireless door lock control, all the doors are locked again automatically.
Answer Back When the doors are being locked or unlocked using the transmitter, the hazard warning lights blink once and wireless door lock buzzer sounds*1 while locking and twice while unlocking.
Security The transmitter sends door lock/unlock operation request signals as a rolling code.

*1: Models for Malaysia


*2: Except models for Malaysia