Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2011.11–2013.04
NM19Y0E _58 Vehicle Interior _003220 SUPPLEMENTAL RESTRAINT SYSTEMS _0016051 AIRBAG SYSTEM CO CONTROL F

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  CONTROL  AIRBAG CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components in the airbag system have the following functions:

Component Function
Center Airbag Sensor Assembly The center airbag sensor assembly receives signals from the deceleration sensor and safing sensor built into the center airbag sensor assembly and the front airbag sensor, determines whether the steering pad (driver side squib) and front passenger airbag assembly should be activated, and diagnoses system malfunctions.
Steering Pad (Driver Side Squib) These consist of an inflator, a bag, and so on. The inflator deploys gas in accordance with an expansion signal from the center airbag sensor assembly and deploys the bag.
Front Passenger Airbag Assembly*
Front Airbag Sensor The deceleration at colliding is detected, and the signal to judge the ignition is sent to center airbag sensor assembly.
Combination Meter Assembly
- SRS Warning Light
The SRS warning light turns on to alert the driver when the center airbag sensor assembly detects a malfunction in the airbag system.

*: Models with front passenger airbag assembly



OPERATING CONDITION


a.

If the impact of a collision is greater than the specified value, the SRS is activated automatically. The center airbag sensor assembly includes the safing sensor and deceleration sensor. The safing sensor is designed to turn on at a lower deceleration rate than the deceleration sensor.

i.

In case of a frontal collision, the center airbag sensor assembly determines whether airbag deployment is necessary based on signals from the deceleration sensor and the front airbag sensor. If the safing sensor turns on simultaneously, current flows to the squibs to deploy the SRS components as shown in the illustration below. However, a deployment ignition signal may be output with the deceleration sensor on signal even without a signal from a front airbag sensor.

Y113974
0.625,0.375 2.531,0.896 1.906,0.521 10 FRONT AIRBAG SENSOR 0.969,1.365 2.229,1.885 1.26,0.521 10 Judgment Circuit 0.948,2.854 2.354,3.406 1.406,0.552 10 Safing Sensor On 0.781,3.542 2.167,4.26 1.385,0.719 10 CENTER AIRBAG SENSOR ASSEMBLY 0.354,4.083 3.969,4.49 3.615,0.406 10 *1: Models with Front Passenger Airbag Assembly 0.354,4.365 2.188,4.813 1.833,0.448 10 *2: Models for South Africa 4.229,1.115 6.833,1.479 2.604,0.365 10 STEERING PAD (DRIVER SIDE SQUIB) 4.458,1.781 6.385,2.531 1.927,0.75 10 FRONT PASSENGER AIRBAG ASSEMBLY*1 4.146,2.74 6.792,3.438 2.646,0.698 10 FRONT SEAT OUTER BELT ASSEMBLIES (PRETENSIONER SQUIB)*2 3.156,2.135 3.813,2.552 0.656,0.417 10 AND




SYSTEM CONTROL


a.

Airbag for Frontal Collision

i.

For frontal collisions, there are 2 airbags and 2 seat belt pretensioners: a steering pad, front passenger airbag assembly, front seat outer belt assembly LH, and front seat outer belt assembly RH. The deployment of the airbags and the activation of the pretensioners occur simultaneously.

Y113977
3,0.469 4.146,1.094 1.146,0.625 10 FRONT AIRBAG SENSOR 5.229,1.406 6.635,2.094 1.406,0.688 10 STEERING PAD (DRIVER SIDE SQUIB) 5.229,2.083 6.667,2.74 1.438,0.656 10 FRONT PASSENGER AIRBAG ASSEMBLY*1 5.229,2.927 6.958,4.083 1.729,1.156 10 FRONT SEAT OUTER BELT ASSEMBLY RH (PRETENSIONER SQUIB)*2 5.229,4.104 6.958,5.281 1.729,1.177 10 FRONT SEAT OUTER BELT ASSEMBLY LH (PRETENSIONER SQUIB)*2 2.854,2.604 4.229,3.438 1.375,0.833 10 CENTER AIRBAG SENSOR ASSEMBLY 0.458,3.052 1.927,3.76 1.469,0.708 10 COMBINATION METER ASSEMBLY 0.292,4.771 3.677,5.146 3.385,0.375 10 *1: Models with Front Passenger Airbag Assembly 0.292,5.135 2.469,5.51 2.177,0.375 10 *2: Models for South Africa 0.5,3.677 2.156,4.208 1.656,0.531 10 - SRS WARNING LIGHT 0.458,2 1.188,2.427 0.729,0.427 10 Collision 1.563,2.01 2.219,2.448 0.656,0.438 10 Impact




DIAGNOSIS


a.

If the center airbag sensor assembly detects a malfunction in the airbag system, the center airbag sensor assembly stores the malfunction data in memory, in addition to illuminating the SRS warning light.


b.

There are 2 types of Diagnostic Trouble Code (DTC) for the airbag system: 5-digit and 2-digit.


c.

The 5-digit DTC can be read by connecting the intelligent tester to DLC3.


d.

The 2-digit DTC can be read by connecting the SST (09843-18040) to the TC and E1 terminals of the DLC3 and reading the blinking of the SRS warning light.


e.

If the SRS airbag deploys, the center airbag sensor assembly will turn on the SRS warning light. However, different from the ordinary diagnosis function, a DTC will not be stored. The SRS warning light cannot be turned off. It is necessary to replace the center airbag sensor assembly with a new one.

Y113978
0.854,1.135 1.427,1.531 0.573,0.396 10 DLC3 2.823,0.948 4.198,1.74 1.375,0.792 10 CENTER AIRBAG SENSOR ASSEMBLY 5.198,1.385 6.885,1.74 1.688,0.354 10 - SRS WARNING LIGHT 5.188,0.583 6.646,1.323 1.458,0.74 10 COMBINATION METER ASSEMBLY