CONSTRUCTION
Wind noise has been reduced by decreasing the difference in height between the front pillar and the windshield glass, and between the front pillar and the door frame (A - A cross section).
The shape of the outer mirror has been optimized, and "dimension e" and "angle f" have been maximized to rectify airflow, reducing wind noise (B - B cross section).
Quarter window outside moulding has been used to eliminate gaps between the rear door and the quarter window glass. This has reduced wind noise caused by air blowing in, and also contributed to improve appearance (C - C cross section).
| *1 | Windshield Glass | *2 | Side Panel Outer |
| *3 | Door Frame | *4 | Outer Mirror |
| *5 | Rear Door Glass | *6 | Quarter Window Outside Moulding |
| *7 | Quarter Window Glass | - | - |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | Minimal Level Difference |
| *e | Dimension e | *f | Angle f |
Asphalt sheets are used to reduce road noise.
|
Asphalt Sheet | - | - |
A dash brace (dash panel to cowl brace) has been applied to the dash panel to suppress panel vibration and reduce engine noise.
A cowl brace (cowl top side reinforcement lower) has been applied to the cowl top panel inner to improve its rigidity and reduce vibration to the steering.
| *1 | Dash Panel | *2 | Dash Panel to Cowl Brace |
| *3 | Cowl Top Panel Inner | *4 | Cowl Top Side Reinforcement Lower |
A fender plate (front fender to cowl side seal) is provided between the side panel outer and the front fender panel. This prevents engine noise from entering the cabin, and achieves superior quietness (A - A cross section).
Soundproofing has been improved by the double-layer seal construction of the front door weatherstrip and the front door opening trim weatherstrip in the front door (B - B cross section).
| *1 | Front Fender to Cowl Side Seal | *2 | Front Fender Panel |
| *3 | Side Panel Outer | *4 | Front Door Panel Sub-assembly |
| *5 | Front Door Opening Trim Weatherstrip | *6 | Front Door Weatherstrip |
| *a | A - A Cross Section | *b | B - B Cross Section |
The hood insulator*, dash panel outer insulator, and dash panel insulator have a double layer of felt to reduce engine noise.
*: Models with 3SZ-VE engine and for Malaysia
| *A | Models with 3SZ-VE Engine and for Malaysia | - | - |
| *1 | Hood Insulator | *2 | Dash Panel Outer Insulator |
| *3 | Dash Panel Insulator | - | - |
Roof silencers have been applied to the roof panel to reduce rain noise.
Urethane has been optimally arrayed within the cross section of each section of the frame to reduce wind and road noise.
| *A | Models with 3SZ-VE Engine | - | - |
| *1 | Roof Silencer | - | - |
|
Sound Absorbing Material (Urethane) | - | - |
Sound absorbing materials and sound insulation materials have been placed optimally throughout the interior in consideration of silent operation. Besides, the thickness of the felt in the rear seat footwell increased* to improve noise vibration characteristics.
*: Models with 3SZ-VE engine
| *a | Increased Thickness | - | - |
|
Sound Absorbing Material | - | - |
Door trim seal has been applied to improve noise vibration characteristics.*
*: Models with 3SZ-VE engine
| *1 | Front Door Trim | *2 | Door Trim Seal |
| *3 | Front Door Scuff Plate | - | - |
| *a | A - A Cross Section | - | - |