CONSTRUCTION
An aerodynamic rib is provided in the lower portion of the front fender liner. As a result, the flow of air is adjusted, thus achieving aero-resistance reduction and fuel efficiency.
| *A | Models with K3-VE Engine, and LHD Models with 3SZ-VE Engine (except Models for Mexico and G.C.C. Countries) | - | - |
| *1 | No. 1 Engine Under Cover Sub-assembly | - | - |
| *a | Rib in Lower Portion of Front Fender Liner | - | - |
|
Air Flow | - | - |
Underfloor rectifier parts are added and the shape has been optimized to control the underfloor airflow, thus ensuring excellent aerodynamic performance.
| *A | Models for Mexico, and RHD Models with 3SZ-VE Engine (except S Grade Models) | - | - |
| *1 | No. 1 Engine Under Cover Sub-assembly | *2 | Rear Engine Under Cover |
| *a | Rib in Lower Portion of Front Fender Liner | - | - |
|
Air Flow | - | - |
| *A | S Grade Models | - | - |
| *1 | No. 1 Engine Under Cover Seal | *2 | No. 1 Engine Under Cover Sub-assembly |
| *3 | Rear Engine Under Cover | - | - |
| *a | Rib in Lower Portion of Front Fender Liner | - | - |
|
Air Flow | - | - |
| *A | Models for G.C.C. Countries | - | - |
| *1 | No. 1 Engine Under Cover Sub-assembly | *2 | Rear Engine Under Cover |
| *a | Rib in Lower Portion of Front Fender Liner | - | - |
|
Air Flow | - | - |
The vertical shape of the rear wheel house liner has been used to decrease air resistance by preventing disturbances and restricting the flow of air from inside the wheel housing to the outside.
| *1 | Rear Wheel House Liner | *2 | Rear Bumper Cover |
| *3 | Rear Tire | - | - |
| *a | A - A Cross Section | *b | Vertical Shape |
|
Air Flow | - | - |
The windshield glass has been sloped backwards, reducing air resistance (Illustration 1).
The rear of the roof panel has been lowered, separating the air flow from the vehicle body and reducing air resistance (Illustration 2).
The shape of the outer mirror has been streamlined for smoother air flow (Illustration 3).
|
Air Flow | - | - |