Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › SFI SYSTEM › from 2015.08
NM19Y0E _51 Engine / Hybrid System _041611 1NR-VE ENGINE CONTROL _0193430 SFI SYSTEM DE DETAILS F

1NR-VE ENGINE CONTROL  SFI SYSTEM  DETAILS  HEATED OXYGEN SENSOR  


CONSTRUCTION


a.

The sensor is installed to the exhaust manifold and detects the oxygen concentration in the exhaust emission by the amount of the electromotive force generated within the sensor.


b.

The lower the oxygen concentration, the greater the electromotive force gets, indicating that the air-to-fuel ratio is rich (rich condition).


c.

Based on this voltage, the engine control computer judges whether the current air-to-fuel ratio is greater or smaller than the stoichiometric ratio.


d.

The sensor begins operating at about 300°C or more. In order to activate the sensor sooner, a heater circuit is provided.


e.

This helps improve accuracy of the air-to-fuel ratio feedback control, thus reducing the exhaust emission.

W128681C01
4.49,1.823 4.49,0.594 4.49,0.594 4.75,0.594 true 4.635,1.75 4.875,1.177 4.875,1.177 5.135,1.177 true 4.563,2.646 4.885,3.135 4.885,3.135 5.031,3.135 true 3.958,3.448 4.167,3.448 4.167,3.448 4.385,2.688 true 3.604,3.104 3.896,3.104 3.896,3.104 4.229,2.531 true 4.802,0.521 5.115,0.792 0.313,0.271 10 false *b 5.167,1.083 5.479,1.281 0.313,0.198 10 false *a 5.073,3.021 5.385,3.219 0.313,0.198 10 false *c 3.781,3.365 4.094,3.563 0.313,0.198 10 false *d 3.427,3.021 3.74,3.219 0.313,0.198 10 false *c
*a Atmosphere *b Heater
*c Platinum Electrode *d Sensor Element (Zirconia)