Home › Power Source / Network › 2NR-VE BATTERY / CHARGING › CHARGING SYSTEM › from 2015.08
NM19Y0E _57 Power Source / Network _041628 2NR-VE BATTERY / CHARGING _0193440 CHARGING SYSTEM CO CONTROL F

2NR-VE BATTERY / CHARGING  CHARGING SYSTEM  CONTROL  CHARGING CONTROL  


SYSTEM CONTROL


a.

This system lowers the generated voltage when the vehicle is not decelerating, and raises the generated voltage when the vehicle is decelerating. This reduces the load on the engine as a result of electric generation of the generator, thus contributing to improved fuel economy. When idling or driving at a constant speed, this system regulates the generated voltage in order to place the amperage estimation value close to the target value.


b.

This control consists of a battery current sensor assembly, generator assembly, various sensors, switches and ECM.


c.

The ECM detects the driving conditions based on signals from various sensors, and detects the charging condition based on signals from the generator assembly and battery sensor.


d.

The ECM stops charging control and the generator switches to normal power generation mode under the following conditions:

i.

Low battery capacity


ii.

Low or high battery temperature


iii.

Wipers operating, blower motor operating or taillight switch on


iv.

Battery current sensor assembly malfunction


v.

Communication failure (local communication between the generator assembly, ECM and the battery current sensor assembly)


vi.

Generator assembly malfunction