CONSTRUCTION
An active type speed sensor is used. This sensor contains a Hall IC.
The front speed sensors use a magnet type sensor rotor, which consists of N and S poles that are arranged in a circle. The front speed sensor rotor is integrated with the hub bearing inner race.
The rear speed sensors use a gear type rotor that is mounted on the rear axle shaft.
| *A | Front Axle | *B | Rear Axle |
| *1 | Front Speed Sensor | *2 | Front Speed Sensor Rotor |
| *3 | Rear Speed Sensor | *4 | Rear Speed Sensor Rotor |
An active type speed sensor uses a sensor IC to detect magnetic field changes caused when the sensor rotor rotates, and the sensor outputs the detected information to the skid control ECU as digital pulses (vehicle speed signal).
To detect the vehicle speed, the frequency of the output pulses is used. Because the active type sensor outputs digital pulses, it can detect the vehicle speed even when the vehicle is nearly stationary.