Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2015.08
NM19Y0E _58 Vehicle Interior _003220 SUPPLEMENTAL RESTRAINT SYSTEMS _0016051 AIRBAG SYSTEM CO CONTROL F

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  CONTROL  AIRBAG CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main components in the airbag system have the following functions:

Component Function
Airbag ECU Assembly
·

The airbag ECU assembly receives signals from the deceleration sensor and safing sensor built into the airbag ECU assembly and the front airbag sensors, determines whether the horn button assembly, instrument panel passenger airbag assembly and front seat outer belt assembly RH/LH should be activated, and diagnoses system malfunctions.

·

The airbag ECU assembly sends an airbag deployment signal to the ECM to operate fuel pump control.


Horn Button Assembly Driver Side Squib These consist of an inflator, a bag, and so on. The inflator deploys gas in accordance with an expansion signal from the airbag ECU assembly and deploys the bag.
Instrument Panel Passenger Airbag Assembly Front Passenger Side Squib
Front Airbag Sensor RH/LH Detects the deceleration of the vehicle during a collision, and transmits the signal to the airbag ECU assembly.
Front Seat Outer Belt Assembly RH/LH Front Pretensioner Squib RH/LH The front seat outer belt assemblies are used to help reduce impact to the occupants.
Combination Meter Assembly SRS Warning Light The SRS warning light turns on to alert the driver when the airbag ECU assembly detects a malfunction in the airbag system.



OPERATING CONDITION


a.

If the impact of a collision is greater than the specified value, the SRS is activated automatically. The airbag ECU assembly includes the safing sensor and deceleration sensor. The safing sensor is designed to turn on at a lower deceleration rate than the deceleration sensor.

i.

In case of a frontal collision, the airbag ECU assembly determines whether airbag deployment is necessary based on signals from the deceleration sensor and the front airbag sensors. If the safing sensor turns on simultaneously, current flows to the squibs to deploy the SRS components as shown in the illustration below. However, a deployment ignition signal may be output with the deceleration sensor on signal even without a signal from a front airbag sensors.

Y133995E01
0.323,0.479 2.24,0.875 1.917,0.396 10 false Front Airbag Sensor RH or LH 0.75,1.448 2.021,1.833 1.271,0.385 10 false Judgment Circuit 0.729,2.958 2,3.344 1.271,0.385 10 false Safing Sensor On 2.969,2.219 3.458,2.688 0.49,0.469 10 false AND 0.635,3.646 2.167,4.031 1.531,0.385 10 false Airbag ECU Assembly 4.563,0.719 6.094,1.104 1.531,0.385 10 false Horn Button Assembly 4.667,1.052 5.938,1.417 1.271,0.365 10 false - Driver Side Squib 3.865,1.604 6.865,2.031 3,0.427 10 false Instrument Panel Passenger Airbag Assembly 4.333,1.938 6.365,2.323 2.031,0.385 10 false - Front Passenger Side Squib 4.177,2.51 6.573,2.865 2.396,0.354 10 false Front Seat Outer Belt Assembly RH 4.323,2.854 6.302,3.219 1.979,0.365 10 false - Front Pretensioner Squib RH 4.177,3.427 6.573,3.781 2.396,0.354 10 false Front Seat Outer Belt Assembly LH 4.333,3.771 6.313,4.135 1.979,0.365 10 false - Front Pretensioner Squib LH




SYSTEM CONTROL


a.

Airbag for Frontal Collision

i.

For frontal collisions, there are 2 airbags and 2 seat belt pretensioners: a horn button assembly, instrument panel passenger airbag assembly, front seat outer belt assembly RH, and front seat outer belt assembly LH. The deployment of the airbags and the activation of the pretensioners occur simultaneously.

Y183830E01
4.417,1.177 4.74,0.552 false 2.833,0.271 4.417,0.833 1.583,0.563 10 false Front Airbag Sensor 0.375,1.802 0.99,2.281 0.615,0.479 10 false Collision 1.521,1.802 2.135,2.281 0.615,0.479 10 false Impact 3.052,2.698 3.854,4.292 0.802,1.594 10 false Airbag ECU Assembly 4.792,0.438 6.719,0.854 1.927,0.417 10 false Spiral Cable Sub-assembly 5.042,1.219 6.656,1.958 1.615,0.74 10 false Horn Button Assembly (Driver Side Squib) 5.073,2.167 6.917,3.167 1.844,1 10 false Instrument Panel Passenger Airbag Assembly (Front Passenger Side Squib) 5.042,3.26 7.042,4.073 2,0.813 10 false Front Seat Outer Belt Assembly RH (Front Pretensioner Squib RH) 5.031,4.333 6.99,5.406 1.958,1.073 10 false Front Seat Outer Belt Assembly LH (Front Pretensioner Squib LH) 1.063,4.917 1.854,5.26 0.792,0.344 10 false ECM 0.406,2.302 2.021,3.313 1.615,1.01 10 false Combination Meter Assembly (SRS Warning Light) 0.438,3.792 2.042,4.438 1.604,0.646 10 false Main Body ECU (Fuse Block Assembly) 0.438,5.375 2.604,5.76 2.167,0.385 10 false : CAN Communication Line




DIAGNOSIS


a.

If the airbag ECU assembly detects a malfunction in the airbag system, the airbag ECU assembly stores the malfunction data in memory, in addition to illuminating the SRS warning light.


b.

There are 2 types of Diagnostic Trouble Code (DTC) for the airbag system: 5-digit and 2-digit.


c.

The 5-digit DTC can be read by connecting the Global TechStream (GTS) to DLC3.


d.

The 2-digit DTC can be read by connecting the SST (09843-18040) to the ECUT and E terminals of the DLC3 and reading the blinking of the SRS warning light.


e.

If the SRS airbag deploys, the airbag ECU assembly will blink the SRS warning light. However, different from the ordinary diagnosis function, a DTC will not be stored. The SRS warning light cannot be turned off. It is necessary to replace the airbag ECU assembly with a new one.

Y113978E03
0.917,1.156 1.49,1.552 0.573,0.396 10 false DLC3 3.135,0.969 3.927,1.708 0.792,0.74 10 false Airbag ECU Assembly 5.313,1.406 6.74,1.865 1.427,0.458 10 false - SRS Warning Light 5.365,0.583 6.594,1.323 1.229,0.74 10 false Combination Meter Assembly