Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT › from 2015.08
NM19Y0E _58 Vehicle Interior _003223 THEFT DETERRENT / KEYLESS ENTRY _0016057 THEFT DETERRENT CO CONTROL F

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT  CONTROL  THEFT DETERRENT CONTROL  


SYTEM CONTROL


a.

The states of the theft deterrent system are as follows:

State Description Theft Detection
Disarmed State The theft deterrent system has not been set by the user. Not possible
Armed Preparation State This is the preparation state before the theft deterrent system becomes active (enters the armed state) when the system has been set by the user. Not possible
Armed State The theft deterrent system is active. (Theft can be detected.) Possible
Alarm State A theft attempt has been detected and the warning operation activates. Possible

Y114116E02
3.646,0.531 4.854,0.969 1.208,0.438 10 Disarmed State 3.302,1.333 5.219,1.823 1.917,0.49 10 Armed Preparation State 3.729,2.094 4.771,2.573 1.042,0.479 10 Armed State 3.698,2.885 4.906,3.396 1.208,0.51 10 Alarm State 4.896,1.083 5.302,1.469 0.406,0.385 10 (1) 4.906,1.844 5.313,2.208 0.406,0.365 10 (2) 4.906,2.635 5.281,3.031 0.375,0.396 10 (4) 3.188,2.49 3.604,2.854 0.417,0.365 10 (6) 3.188,0.917 3.667,1.292 0.479,0.375 10 (3) 2.208,2.292 2.719,2.667 0.51,0.375 10 (5) 2.208,3.083 2.656,3.521 0.448,0.438 10 (5)


b.

The theft deterrent system activates as shown in the diagram above when one of items in the table occurs in order to cause the system to enter the respective state.

Condition Item
(1) Any door is opened and closed using the wireless door lock function while the engine hood is closed and all doors are locked.
(2)
·

The system switches to the armed state when the doors, engine hood is closed and locked.*1

·

The system switches to the armed state when the doors, engine hood is closed and locked, and 30 seconds have elapsed.*2


(3) The system switches to the disarmed state when one of the following conditions is met:
·

Doors are unlocked using the wireless door lock function.

·

Any door is opened.

·

The ignition key is inserted in the ignition key cylinder.

·

The ignition switch is turned to ON.

·

The battery terminal is disconnected and reconnected.*1

·

The engine hood is opened.


(4) The system switches to the alarm state when one of the following conditions is met:
·

The engine hood is opened.

·

Any door is opened while all doors are closed.

·

Theft deterrent system circuit wires have been cut.

·

The ignition switch is changed to ON without the key (a remote control starter is not in use at this time).

·

Intrusion sensor detected an intrusion.*2


(5) The system switches to the disarmed state when one of the following conditions is met:
·

Any door is unlocked with wireless door unlock function.

·

The ignition switch is turned to ON with the key and 2 seconds have elapsed since the engine was started.


(6) The system reverts to the armed state after the alarm time elapses.

*1: Models without theft warning ECU assembly

*2: Models with theft warning ECU assembly




FUNCTION


a.

The theft deterrent system has the following functions:

Function Outline
Alarm When the theft deterrent system switches to the alarm state, the warning items are operated and the alarm sounds for approximately 30 seconds.
Alarm Indicator When the theft deterrent system switches to the armed preparation state or alarm state, the security indicator light is illuminated to inform the user. This indicator is also the engine immobiliser indicator, which blinks when the engine immobiliser is in the set state.
Forced Door Lock The main body ECU (fuse block assembly) transmits a door lock signal to all the doors when all the following conditions are met:
·

The theft deterrent system is in the alarm state.

·

One of the doors has been unlocked.


The function stops when one of the following conditions is met:
·

All doors are locked.

·

The warning ends after approximately 30 seconds.


Panic Control* When the lock button of the door control transmitter continuously for 1.5 seconds or more is pressed, the main body ECU (fuse block assembly) operates the alarm function.

*: Models with theft warning ECU assembly