OUTLINE
Highly Rigid Body and Light Weight
High-tensile strength steel is used in order to achieve excellent body rigidity and a lightweight body.
Safety Features
The impact absorbing structure minimizes cabin deformation by effectively helping to absorb the impact energy in the event of a front, side or rear collision. This provides high safety performance.
A "brake pedal anti-back system" that pushes the brake pedal downwards in the event of a frontal collision, thus reducing the amount of brake pedal retreat has been used in order to mitigate impact to the driver's lower extremities.
Knee bolsters (No. 1 instrument panel safety pad and No. 2 instrument panel safety pad) have been added to the driver's side of the instrument panel, reducing injury to the chest and lower extremities.
Rust-resistant Body
Rust-resistant performance is enhanced by the extensive use of anti-corrosion sheet steel, as well as by an anti-corrosion treatment that includes the application of anti-rust wax, sealer and anti-chipping paint to easily corroded parts such as the edge of the door lower portion, door hinge, the fuel filler lid hinge, the hemmed portions of the hood panel and each part of the deck.
Low Vibration and Low Noise Body
Effective application of vibration damping and noise suppressant materials reduces engine, wind and road noise.
Aerodynamics
Optimization of the shape of the body and underfloor ensures excellent aerodynamic performance.
MAIN FEATURES
Exterior Design
Front View
A relief that extends from the hood bulge to the upper grille has been used in combination with a three-dimensional aspect focused on the ornament to achieve a strong, projecting feel for the entire front of the vehicle.
The wheel flares at left and right blend with the vehicle body, giving it a feeling of stability and making it look as though it has a low center of gravity.
Side View
Ramps to absorb force have been put in place on both ends of the shoulder axes at front and rear, shaped to offer a relaxed, yet strong feel to the cabin.
The wheel flares that enclose the tires have been curved to flow into the lower surfaces of the ramp at both front and rear, and the four corners of the vehicle body have clear outlines to convey an impression of firm stability.
A relief has been used from the front wheel to the rear wheel flare, adding life to the sides of the body and shaped so that it flows into the volume of the rear bumper.
Rear View
The area to the left, right, above, and below the license plate at the center of the back door is slightly flared out, which has been shaped to offer a strong feel to the rear view.
The wheel flares at left and right have been given a dynamic shape to blend with the vehicle body, projecting a sense of stability and a low center of gravity.
S grade
By using a dedicated front bumper, rear bumper, and rocker panel moulding to emphasize the vehicle's sporty image, the design is differentiated from the standard-grade model, giving it an identity appropriate to the flagship AVANZA model.
| *1 | Front Bumper | *2 | Rocker Panel Moulding |
| *3 | Rear Bumper | - | - |