CONSTRUCTION
Wind noise has been reduced by decreasing the difference in height between the front pillar and the windshield glass, and between the front pillar and the door frame (A - A cross section).
The shape of the outer mirror has been optimized, and "dimension e" and "angle f" have been maximized to rectify airflow, reducing wind noise (B - B cross section).
Quarter window outside moulding has been used to eliminate gaps between the rear door and the quarter window glass. This has reduced wind noise caused by air blowing in, and also contributed to improve appearance (C - C cross section).
| *1 | Windshield Glass | *2 | Side Panel Outer |
| *3 | Door Frame | *4 | Outer Mirror |
| *5 | Rear Door Glass | *6 | Quarter Window Outside Moulding |
| *7 | Quarter Window Glass | - | - |
| *a | A - A Cross Section | *b | B - B Cross Section |
| *c | C - C Cross Section | *d | Minimal Level Difference |
| *e | Dimension e | *f | Angle f |
An asphalt sheet is used to reduce road noise.
|
Asphalt Sheet | - | - |
A dash brace (dash panel to cowl brace) has been applied to the dash panel to suppress panel vibration and reduce engine noise.
A cowl brace (cowl top side reinforcement lower) has been applied to the cowl top panel inner to improve its rigidity and reduce vibration to the steering.
| *1 | Dash Panel | *2 | Dash Panel to Cowl Brace |
| *3 | Cowl Top Panel Inner | *4 | Cowl Top Side Reinforcement Lower |
| *5 | Cowl Top Reinforcement Inner Upper | - | - |
A fender plate (front fender to cowl side seal) is provided between the side panel outer and the front fender panel. This prevents engine noise from entering the cabin, and achieves superior quietness (A - A cross section).
Soundproofing has been improved by the double-layer seal construction of the front door weatherstrip and the front door opening trim weatherstrip in the front door (B - B cross section).
| *1 | Side Panel Outer | *2 | Front Fender to Cowl Side Seal |
| *3 | Front Fender Panel | *4 | Front Door Panel Sub-assembly |
| *5 | Front Door Opening Trim Weatherstrip | *6 | Front Door Weatherstrip |
| *a | A - A Cross Section | *b | B - B Cross Section |
The hood insulator, dash panel outer insulator and dash panel insulator have a double layer of felt to reduce engine noise.
*: Models with hood insulator
| *A | Models with Hood Insulator | - | - |
| *1 | Hood Insulator | *2 | Dash Panel Outer Insulator |
| *3 | Dash Panel Insulator | - | - |
Roof silencers have been applied to the roof panel to reduce rain noise.
Urethane has been optimally arrayed within the cross section of each section of the frame to reduce wind and road noise.
| *A | Models with Rear Center Seat Outer Belt Assembly for tropic | *B | Models with Rear Center Seat Outer Belt Assembly except tropic |
| *C | Models without Rear Center Seat Outer Belt Assembly | - | - |
| *1 | Roof Silencer | - | - |
|
Sound-absorbing Material (Urethane) | - | - |
Sound-absorbing materials have been placed optimally throughout the interior in consideration of silent operation.
|
Sound-absorbing Material | - | - |
Door trim seal has been applied to improve noise vibration characteristics.
| *1 | Front Door Trim | *2 | Door Trim Seal |
| *3 | Front Door Scuff Plate | - | - |
| *a | A - A Cross Section | - | - |