Home › Engine / Hybrid System › 2NR-VE ENGINE MECHANICAL › ENGINE UNIT › from 2015.08
NM19Y0E _51 Engine / Hybrid System _041614 2NR-VE ENGINE MECHANICAL _0199634 ENGINE UNIT DE DETAILS F

2NR-VE ENGINE MECHANICAL  ENGINE UNIT  DETAILS  CRANKSHAFT AND BEARING  


CONSTRUCTION


a.

The crankshaft has 5 main journals and 8 balance weights.


b.

The pins and journals have been machined with increased precision and the surface roughness has been minimized to reduce friction.

W128701C01
1.792,0.219 2.219,0.219 2.219,0.219 2.417,0.646 true 4.604,0.688 4.719,0.167 4.719,0.167 4.938,0.167 true 1.406,2.469 1.646,2.469 1.646,2.469 2,1.615 true 5.833,1.563 6.115,2.438 6.115,2.438 6.458,2.438 true 1.604,0.146 1.917,0.344 0.313,0.198 10 false *1 4.99,0.094 5.302,0.292 0.313,0.198 10 false *2 1.198,2.375 1.51,2.573 0.313,0.198 10 false *3 6.51,2.344 6.823,2.542 0.313,0.198 10 false *4
*1 Oil Hole *2 Balance Weight
*3 No. 1 Journal *4 No. 5 Journal



c.

The width of the crankshaft bearings has been optimized to reduce friction.


d.

The lining surface of the crankshaft bearing is micro-grooved to provide an optimal oil clearance. As a result, cold-engine cranking performance has been improved and engine vibration has been reduced.


e.

An oil groove is provided on each upper main bearing (crankshaft bearing). The oil groove is deep at the center and is shallow at the edges to reduce the amount of oil that will leak from the crankshaft bearing. As a result, the size of the oil pump has been reduced, thus minimizing friction.

W100984C01
3.792,2.583 4.073,3.135 4.073,3.135 4.115,3.135 true 3.531,1.083 3.271,0.448 3.271,0.448 3.177,0.448 true 1.583,1.906 1.385,1.375 1.385,1.375 1.313,1.375 true 3,0.365 3.281,0.594 0.281,0.229 10 *1 5.427,0.615 5.604,0.844 0.177,0.229 10 *c 6.656,1.469 6.833,1.698 0.177,0.229 10 *d 4.25,1.469 4.427,1.698 0.177,0.229 10 *d 5.438,2.031 5.615,2.26 0.177,0.229 10 *b 4.156,3.063 4.333,3.292 0.177,0.229 10 *2 1.146,1.281 1.323,1.51 0.177,0.229 10 *a
*1 Upper Main Bearing (Crankshaft Bearing) *2 Lower Main Bearing (Crankshaft Bearing)
*a Micro-grooved *b Oil Groove Depth
*c Center *d Edge