Home › Engine / Hybrid System › 2NR-VE EMISSION CONTROL › EMISSION CONTROL SYSTEM › from 2015.08
NM19Y0E _51 Engine / Hybrid System _041618 2NR-VE EMISSION CONTROL _0199635 EMISSION CONTROL SYSTEM GE GENERAL F

2NR-VE EMISSION CONTROL  EMISSION CONTROL SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

Three-Way Catalytic converter (TWC) is used to reduce exhaust gas emissions.


b.

Based on the signal from the heated oxygen sensor, the ECM controls the fuel injection volume in order to optimize the emissions in the exhaust gas.


c.

A blowby gas ventilation system, which efficiently ventilates blowby gas containing HC from the crankcase, is used.


d.

Evaporative emission control, which regulates the purge flow of evaporative emissions (HC) in the canister in accordance with the engine conditions, is used.


e.

Oxygen sensor heater control, which maintains the temperature of the respective sensors at an appropriate level, is used to ensure the detection accuracy of oxygen concentration in exhaust gas.