FUNCTION OF MAIN COMPONENTS
The main components of the 1NR-VE emission control system are as follows.
| Component | Function |
|---|---|
| TWC | The TWC reduce emissions by oxidation of CO and HC in exhaust gas and reduction of NOx. |
| Oxygen Sensor | Detects the oxygen concentration in the exhaust emission by measuring the electromotive force which is generated in the sensor itself. |
| ECM | ·
Determines an optimal fuel injection volume based on the signals from various sensors. ·
Sends signals to the Purge VSV to control the purge flow. |
| Ventilation Valve Sub-assembly | Opens and closes the valve using vacuum generated in the intake manifold and controls the flow rate of the blowby gas. |
| Purge VSV (Duty Vacuum Switching Valve Assembly) | Open and closes the valve based on signal from ECM and controls the flow rate of the evaporative emission. |
| Charcoal Canister Assembly | Contains activated charcoal to absorb the fuel vapor created in the fuel tank assembly. |
SYSTEM CONTROL
Blowby Gas Ventilation System
By introducing blowby gas that has a large amount of HC into the air intake and burning it again, the system attempts to enhance the emission performance. Returning blowby gas volume is regulated to the appropriate amount corresponding to the engine operating conditions, reducing the engine oil volume consumed and engine idling speeds.
The ventilation valve sub-assembly passage returns blowby gas into the area after the throttle valve in accordance with the intake manifold vacuum.
When load is low, the passage from the cylinder head cover sub-assembly to the area before the throttle valve increases the air purification performance inside the crankcase by introducing fresh air, and when load is high, the passage circulates the blowby gas together with the ventilation valve sub-assembly side passage due to the intake manifold vacuum.
An oil separator is located in the cylinder head cover sub-assembly. This contributes to the compactness of the entire engine.
| *1 | Ventilation Valve Sub-assembly | *2 | Ventilation Hose |
| *3 | No. 2 Ventilation Hose | *4 | Air Cleaner Case Sub-assembly |
| *5 | Throttle Body with Motor Assembly | *6 | Crankcase |
| *a | Fresh Air | *b | Blowby Gas |