Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.09
NM19Y0E _53 Suspension _059360 TIRE PRESSURE MONITORING _0290458 TIRE PRESSURE WARNING SYSTEM CO CONTROL F

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  CONTROL  TIRE PRESSURE WARNING CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Tire Pressure Monitor Valve Sub-assembly Detects the tire pressure, internal temperature and rotational acceleration of the tire, and transmits the measured values and the ID code to the tire pressure monitor receiver assembly.
Tire Pressure Monitor Receiver Assembly
·

Receives the data from the tire pressure monitor valve sub-assembly and monitors the tire inflation pressure.

·

Outputs the respective signal to the combination meter assembly when a drop in the tire inflation pressure, a system malfunction or the beginning of initialization is detected.


Tire Pressure Warning Switch The warning threshold is calculated from the tire inflation pressure value at the time of initialization and memorized in the tire pressure monitor receiver assembly by operating the tire pressure warning switch.
Combination Meter Assembly Tire Pressure Warning Light
·

Illuminates or stays on after blinking for 1 minute to warn the driver in accordance with the signal from the tire pressure warning system.

·

Flashes 3 times after initialization.


Speedometer Sends a vehicle speed signal to the tire pressure monitor receiver assembly.


FUNCTION


a.

Warning Function

i.

The tire pressure warning system has 2 warning methods which are used depending on the condition detected.


ii.

The table below shows the warning methods for the tire pressure warning light in the combination meter assembly:

Detection Condition Tire Pressure Warning Light
The tire pressure warning system has detected that the tire pressure has become lower than the warning threshold. Illuminates*1
The tire pressure warning system has detected a malfunction in the system. Illuminates after blinking for 1 minute*2

HINT:

*1: If the tire pressure warning light illuminates, adjust the tire pressure.

*2: If the tire pressure warning light stays on after blinking for 1 minute, the system is malfunctioning and must be repaired in order to turn off the light. For details, refer to the Repair Manual.




b.

Initial Check Function

i.

After the ignition switch is ON, the tire pressure monitor receiver assembly illuminates the tire pressure warning light for 3 seconds to check the warning light circuits.



c.

Initialization Function

i.

The warning threshold is calculated from the tire inflation pressure value and memorized in the tire pressure monitor receiver assembly. Therefore, the tire pressure monitor receiver assembly should be initialized after:

·

The recommended tire inflation pressure changes due to changes in vehicle weight, speed conditions or tire size.

·

The tire pressure monitor receiver assembly or the tire pressure monitor valve sub-assembly are replaced.

·

The tires are rotated on a vehicle with different recommended tire inflation pressures for the front and rear tires.

·

The tire pressure is adjusted.



ii.

Initialization starts after the tire pressure warning switch is pressed and held (with the ignition switch ON and with the vehicle stopped) and the tire pressure warning light illuminates slowly 3 times.


iii.

Before performing initialization, adjust the tire inflation pressure to the recommended pressure when the tires are cold. For details, refer to the Repair Manual.


iv.

The tire pressure warning switch is not used to cancel the warning. Do not press the tire pressure warning switch to turn off the tire pressure warning light.




DIAGNOSIS


a.

To inform the driver when the tire pressure monitor receiver assembly detects a malfunction in the system, the tire pressure monitor receiver assembly will blink the tire pressure warning light for 1 minute, after which the light will stay on. It will also store the Diagnostic Trouble Codes (DTCs) in memory.


b.

5-digit DTCs can be read by connecting a Global TechStream (GTS) to the DLC3. For details, refer to the Repair Manual.