CONSTRUCTION
The tire pressure monitor valve sub-assemblies are integrated into the tire valves. Each transmitter consists of a lithium battery, sensor and transmitter.
Make sure not to damage the urethane-covered backside of the transmitter (the surface opposite to the side with the ID code) with anything sharp.
The transmitter directly measures tire inflation pressure and temperature to see if the vehicle can continue to run.
The transmitter transmits the measured tire inflation pressure and temperature values to the tire pressure monitor receiver assembly on a frequency of 433.90 MHz.
Depending on the timing of the data transmission, it may take several minutes to receive the data from the tire pressure monitor valve sub-assembly.
The ID code is written on the tire pressure monitor valve sub-assembly.
| *1 | Tire Pressure Monitor Valve Sub-assembly | *2 | Grommet |
| *3 | Washer | *4 | Nut |
| *5 | Tire Valve Core | *6 | Tire Valve Cap |
| *a | Lithium Battery | *b | Sensor and Transmitter |
| *c | ID Code (Hexadecimal 7 Digits) | - | - |
The lithium batteries of the tire pressure monitor valve sub-assemblies are non-replaceable. If the battery is depleted, the tire pressure monitor valve sub-assembly must be replaced (battery life: approximately 10 years).
A new tire pressure monitor valve sub-assembly is shipped in sleep mode to prevent the battery from depleting in storage. When the tire inflation pressure in the detection portion of the tire pressure monitor valve sub-assembly increases or decreases by 40 kPa (5.8 psi, 0.4 bar) within 30 seconds, the tire pressure monitor valve sub-assembly automatically cancels sleep mode. Once sleep mode is canceled, the tire pressure monitor valve sub-assembly cannot return to sleep mode.
When replacing a tire pressure monitor valve sub-assembly, each of the tire pressure monitor valve sub-assembly ID codes must be registered. If even one of the tire pressure monitor valve sub-assemblies is replaced, the ID codes of all tire pressure monitor valve sub-assemblies must be registered again. Record all existing ID codes before beginning the process to enter new ID codes.
To register an ID code, use a Global TechStream (GTS) to enter the ID code that is indicated on the tire pressure monitor valve sub-assembly.
Be careful not to damage the tire pressure monitor valve sub-assemblies when removing and reinstalling them.
Replace the grommet, valve core, washer and nut with new ones when replacing or removing and reinstalling the tire pressure monitor valve sub-assembly. This is necessary to ensure sealing performance.
When replacing a valve cap, use only the specified cap. If an unspecified cap is used, it may seize to the tire pressure monitor valve sub-assembly.
For details, refer to the Repair Manual.