Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014957 CAMSHAFT OIL CONTROL VALVE G

K3-VE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.
A193057C04
0.115,0.094 0.417,0.365 0.302,0.271 10 *a
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the camshaft timing oil control valve assembly.


b.
A235497C05
0.094,0.073 0.479,0.448 0.385,0.375 10 *a 0.521,0.51 1,0.896 0.479,0.385 10 *b 0.531,1.833 1.073,2.177 0.542,0.344 10 *c
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)
*b When applied
*c When cut off


Check the operation

i.

Connect the positive (+) lead from a battery to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

NOTICE:

Confirm that the valve moves freely and does not stick in any position.


If necessary, replace the camshaft timing oil control valve assembly.

HINT:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be stored.