Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014957 CAMSHAFT OIL CONTROL VALVE G

K3-VE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 15330 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the intelligent tester or Techstream to the DLC3.


b.

Start the engine and warm it up.


c.

Turn the intelligent tester or Techstream on.


d.

Inspect the camshaft timing oil control valve.

i.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1).


ii.

Check the engine speed when the camshaft timing oil control valve is operated using the intelligent tester or Techstream with the engine coolant temperature at 50°C (122°F) or less.

HINT:
·

When performing the Active Test, the air conditioning should be on.

·

Engine coolant temperature when the engine is started should be 30°C (86°F) or less.



OK:
Control Range Specified Condition
OFF Normal engine speed
ON Rough idle or engine stalls (soon after camshaft timing oil control valve switched from off to on)