Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › RELAY › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014959 RELAY G

K3-VE ENGINE CONTROL  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT EFI MAIN RELAY

a.

Remove the EFI MAIN relay from the relay block.


b.
E209082

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 No battery voltage is applied across terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage is applied across terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.


Hide 2.INSPECT FUEL PUMP RELAY

a.

Remove the fuel pump relay from the relay block.


b.
E209082

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 No battery voltage is applied across terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage is applied across terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.