Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › THROTTLE BODY › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014960 THROTTLE BODY G

K3-VE ENGINE CONTROL  THROTTLE BODY  INSPECTION  


PROCEDURE

Hide 22210 1.INSPECT THROTTLE BODY ASSEMBLY

a.
A126619C03
2.688,0.354 3.063,0.25 true 2.656,0.833 2.958,1.271 true 2.427,1.125 2.208,1.802 true 3.104,0.156 3.385,0.479 0.281,0.323 10 *1 2.125,1.823 2.542,2.167 0.417,0.344 10 *2 2.927,1.313 3.271,1.677 0.344,0.365 10 *a
*1 Throttle Stop Screw
*2 Throttle Lever
*a No clearance


Check that the throttle valve shaft does not rattle.


b.

Check that none of the ports are clogged.


c.

Check that the throttle valve opens and closes smoothly.


d.

Check that there is no clearance between the throttle stop screw and throttle lever when the throttle valve is fully closed.

NOTICE:

Do not adjust the throttle stop screw.



Hide 89690 2.INSPECT IDLE SPEED CONTROL VALVE

A126620C03
1.365,0.042 1.75,0.396 0.385,0.354 10 *a
*a Component without harness connected
(Idle Speed Control Valve)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 1 27°C (81°F) 45.6 to 50.4 Ω
4 - 2 27°C (81°F) 45.6 to 50.4 Ω


If the result is not as specified, replace the idle speed control valve.


Hide 89452G 3.INSPECT THROTTLE POSITION SENSOR

A126615C03
1.813,0.531 1.729,0.75 true 2.01,0.521 2.094,0.74 true 2.26,0.438 2.49,0.438 true 1.375,0.021 1.833,0.469 0.458,0.448 10 *a 2.563,0.365 3,0.708 0.438,0.344 10 VC 2.104,0.719 2.427,1.042 0.323,0.323 10 - 1.521,0.792 2.135,1.156 0.615,0.365 10 PSW
*a Component without harness connected
(Throttle Position Sensor)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (VC) - 2 (-) 25°C (77°F) 2.5 to 5.0 Ω


If the result is not as specified, replace the throttle position sensor.


b.

Check the resistance change when the throttle lever is fully closed and opened.

Standard:

The resistance increases in proportion to the angle of the throttle lever.


Standard Resistance (HINT):
Tester Connection Condition Specified Condition
2 (-) - 3 (PSW) Fully closed 0.3 to 5.8 kΩ
2 (-) - 3 (PSW) Fully open 1.98 to 9.16 kΩ


If the resistance is not as specified, replace the throttle position sensor.