Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014963 CRANKSHAFT POSITION SENSOR A

K3-VE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A269352C03
1.563,1.417 1.563,1.677 false 1.448,1.708 1.927,2.063 0.479,0.354 10 *1
*1 O-ring


Apply a light coat of engine oil to the O-ring.


b.

Install the crankshaft position sensor with the bolt.

Torque:
7.5 N*m (77 kgf*cm, 66 in.*lbf)


c.

Connect the crankshaft position sensor connector.


Hide 51443 2.INSTALL REAR ENGINE UNDER COVER (for Full Cover Type)

Hide 51441 3.INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

Hide 51441D 4.INSTALL ENGINE UNDER COVER (for Half Cover Type)

Hide 5.INSPECT FOR ENGINE OIL LEAK