Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014963 CRANKSHAFT POSITION SENSOR G

K3-VE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11301K 1.INSPECT CRANKSHAFT POSITION SENSOR

a.
A261467C04
0.125,0.073 0.615,0.458 0.49,0.385 10 *a
*a Component without harness connected
(Crankshaft Position Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Cold 1630 to 2740 Ω
Hot 2065 to 3225 Ω


HINT:

In the table above, the terms "Cold" and "Hot" refer to the temperature of the coils. Cold means approximately -10 to 50°C (14 to 122°F). Hot means approximately 50 to 100°C (122 to 212°F).


If the resistance is not as specified, replace the crankshaft position sensor.