Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › HEATED OXYGEN SENSOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014969 HEATED OXYGEN SENSOR A

K3-VE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL HEATED OXYGEN SENSOR

a.
A266480C03
1.781,1.292 2.354,1.552 false 2.188,0.219 2.625,0.604 0.438,0.385 10 *1 2.385,1.531 3.073,1.927 0.688,0.396 10 SST
*1 Fulcrum Length


Using SST, install the heated oxygen sensor.

SST
09224-00010  

Torque:
without SST : 34 N*m (347 kgf*cm, 25 ft.*lbf)
with SST : 31 N*m (316 kgf*cm, 23 ft.*lbf)

NOTICE:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




b.

Connect the heated oxygen sensor connector.


Hide 2.INSPECT FOR EXHAUST GAS LEAK