Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › HEATED OXYGEN SENSOR › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014969 HEATED OXYGEN SENSOR G

K3-VE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR

a.
A119369C11
1.531,1.198 0.979,1.01 true 1.938,1.198 2.479,1.01 true 1.552,1.594 0.958,1.781 true 2.552,0.927 3.313,1.458 0.76,0.531 10 HTR- 0.563,0.906 1.302,1.479 0.74,0.573 10 HTR+ 0.792,1.719 1.313,2.146 0.521,0.427 10 E 0.135,0.146 0.656,0.594 0.521,0.448 10 *a
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HTR-) - 2 (HTR+) 20°C (68°F) 11.7 to 15.5 Ω
1 (HTR-) - 4 (E) Always 10 kΩ or higher


If the result is not as specified, replace the sensor.