Home › Engine / Hybrid System › K3-VE ENGINE CONTROL › SFI SYSTEM › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002967 K3-VE ENGINE CONTROL _0014971 SFI SYSTEM D

K3-VE ENGINE CONTROL  SFI SYSTEM  DIAGNOSIS SYSTEM  


EURO-OBD (EUROPE)


FI02547

When troubleshooting Europe On-Board Diagnostic (Euro-OBD) vehicles, the vehicle must be connected to an OBD scan tool (complying with ISO 14230-4). Various data output from the vehicle's ECM can then be read.

Euro-OBD regulations require that the vehicle's on-board computer illuminate the Malfunction Indicator Lamp (MIL) on the instrument panel when the computer detects a malfunction in:

1. The emission control system/components

2. The power train control components (which affect vehicle emissions)

3. The computer

In addition, the applicable Diagnostic Trouble Codes (DTCs) prescribed by ISO 14230-4 are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.

To check DTCs, connect the intelligent tester to the Data Link Connector 3 (DLC3) of the vehicle.

The tester displays DTCs, the freeze frame data and a variety of engine data.

The DTCs and freeze frame data can be erased using the tester (See page Engine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).


M-OBD (EXCEPT EUROPEAN SPEC.)


FI02547

When troubleshooting Multiplex On-Board Diagnostic (M-OBD) vehicles, the vehicle must be connected to the intelligent tester. Various data output from the ECM can then be read.

OBD regulations require that the vehicle's on-board computer illuminate the MIL on the instrument panel when the computer detects a malfunction in:

1. The emission control system/components

2. The power train control components (which affect vehicle emissions)

3. The computer

In addition, the applicable DTCs are recorded in the ECM memory. If the malfunction does not recur in 3 consecutive trips, the MIL turns off automatically but the DTCs remain recorded in the ECM memory.


2-TRIP DETECTION LOGIC


When a malfunction is first detected, the malfunction is temporarily stored in the ECM memory (1st trip). If the same malfunction is detected again after the ignition switch is turned to off and then to ON, the MIL illuminates (2nd trip).


DLC3 (Data Link Connector 3)


Check the DLC3 (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION).


BATTERY VOLTAGE


Standard voltage:

11 to 14 V


If voltage is below 11 V, replace or recharge the battery before proceeding.


MIL (Malfunction Indicator Lamp)


a.

The MIL is illuminated when the ignition switch is first turned to ON (the engine is not running).


b.

The MIL should turn off when the engine is started. If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.

HINT:

If the MIL is not illuminated when the ignition switch is first turned to ON, check the MIL circuit (See page Engine / Hybrid System>K3-VE ENGINE CONTROL>SFI SYSTEM>MIL Circuit).